www.imoc.co.uk

cheers djpkins il have a good look tonight

hi everyone i own a rev3 1996 tubby and im sure i have a boost leak occasionally my car boosts to 0.4bar when its set at 0.9bar iv replaced a few of the boost hoses checked clamps and fittings but still im sure i can really faintly hear it hissing away im waiting for some new hose to come through th...

im booked happy days

can anyone share some inf on this i pick my ecu up next friday so could do to get it booked

Cheers rob not to far from me

Were would the mapping take place out of intrest might have to get organised ?

im in hull and i need mapping beginning of may theres 2

hi guys iv got a rev3 tubby with manual boost controller,air filter,full exhaust system

its set to 0.9 bar of boost but when i have the car at full throttle it holds 0.9 for about a second then it slowly drops off to about 0.4 bar im assuming i gotta boost leak so were do i start

hi everyone just wondering whats the going rate for a complete rev2 forged engine,eagle rods,wiseco pistons,acl bearings,arp bolts all manifolds and sensors etc? if you were to buy complete what would they usually go for thanks evry1

well no iv got a fully forged rev2 engine at about 400bhp and precision 5431 turbo so its near brand new and it seems a shame to part with it when its done near no miles so im going to put it in a gt4st205 so i was wondering what parts and involvement was involved as far as i knew it was just a rev2...

how much work is involved and what parts are involved to change a rev2 mr2 engine into a rev3 gt4? any help is appreciated

hi just wondering whats the best way to run in a newly built engine the specs as follows forged pistons 86.5mm eagle rods arp bolts and studs mahle bearings fensport gasket precision 5431 turbo .63ar bmic with 3" pipework iv been given a diagram off a freind but it seems a bit excessive any hel...

hi all does anyone have a guide to adjust the windows on a mr2 tbar iv got a slight gap off approx 2-3mm at the top of the window any help is greatly appreciated

Cheers mark

Anyone know were to get a precsion turbo exhaust flange with 2" outlet 4bolt type cheers

cheers mark another little niggle sorted

cheers pal iv got them all connected now cheers for your help

no its got precision turbo 3431, tial 38mm wastegate,bmic,avcr,fcd,safc loads of other little bits

so if i decided to remove the bov instead of replumbing it to my bmic system it would then over fuel more?

so i connest one end of the boost control solanoid to the compresser housing the other end to the side wastegate port?