www.imoc.co.uk

just looked at my engine (its on a build stand in the garage) and i would say yes, if that main crank seal was leaking you would prob see oil on the back of the flywheel... it could be leaking through the ali plate that the oil seal is sat in, that has a U shaped gasket and if the bolts are not tigh...

lol this build is crazy... i love it!

i cracked my crank pully when i took it off... but i removed it with a very big hammer :thumleft: i would have though toyota would have a special tool for taking the pully off... reading through the workshop manual for the mr2 they have a special service tool for every other job!! lol saying that th...

Hi Guys, My engine rebuild is going well so im starting to turn my attention to the electrics :pale: I have ALL the elecrics from a 95 gt4 (apart from door and rear lights) and its ALOT!!! what i want to know is how much do i have to keep to get the engine running as it should and what can i ditch, ...

Just wanted to say a big thanks to Rogue, i gave them a call at the start of my engine rebuild just to get some advise and one of the guys from the workshop called me back that afternoon to answer all my questions and i hadn't even ordered anything from them :clap: when it came to order the parts i ...

Theres every chance the guy that you sent the spoiler to may have a valid reason for not getting back in contact with you, he may be ill or something, you never know :pray: If thats not the case, you do still have his address, either go round and take the spoiler back (pull it off his car if you hav...

i got this on my gt4 after i fitted a very big intercooler
if i let off the gas very quickly the ssqv would dump the air but if i let off very slowly the ssqv would stay shut and i got the turbo chatter noise... it is a cool noise

toyota had them £6.05 plus vat each

hey guys,

iv got a 'full' engine gasket set but it doesn't include the water pump and oil pump gaskets

any idea where i can get these from? is it Mr T only???

thanks guys

£3500 thats a bargin mate! if i wasn't moving house right now i would have it off you in a heart beat!
good luck with the sale mate.

2nd that! tell them you will be sending the engine back along with a spoon so they can eat your ass! :evil: I got a rev3 through ebay for £200, its in bits and needs a rebuild but will be good as new with new bearings, gaskets etc, and will cost less than an engine from crooks r us! engines pop up o...

I had this problem not long ago, it wouldn't come off with me hanging off a breaker bar but seemed to come off ok when i put a sockek on it and gave it a sharp smack with a hammer. mind the pully though, i slipped with the hammer and clipped the side of the pully :oops: it took a large chunk out of ...

thanks for that guys, thats great

cool, happy days,

thanks for that mate

Iv had a good look around this morning and the only place i can find them is fensport at £104, is there a cheaper place to get them or is fensport it? you can get them from the US for about £30 but who knows if there any good :-k would suck to try and save some cash on the re-build by fitting cheape...

i found the answer in a toyota work shop manual...

Cylinder bore diameter is determined by size mark on
cylinder block deck surface. See Fig. 30. Maximum
bore diameter is 3.3949" (86.230 mm).

thanks for the info guys, very helpful

cool, thanks bud that makes sence now

have you had a look in the for sale section? im sure there was a new clutch for sale

why do you have to fit a re-circ to the rev1's?