www.imoc.co.uk

Toyota it is then, only want to do it once.......fingers crossed 😃

Found this for £106 delivered, including 1mm steel head gasket, anyone used them?

http://www.ebay.co.uk/itm/130970641619

Any recommendations on places to purchase a full engine gasket set, including metal head gasket for a Rev3 turbo, looking for a sensible cost/quality compromise?
Thanks

I have, but only just

Will do....

Thanks

I've been looking but the few I have found have been over £200......

Am I looking in the wrong places???

Cost............

I can get one delivered to the door for just under £150 including postage/duty.

Would a U.S./Canadian market ecu work??

Not used for around 10 years.........

I'm guessing these have gone?

If the rev3 motor is going in ill at least compression/leak down test it, but other than an engine dyno I'll only know for sure if it's a goodin once it's in and running.
Fingers crossed the engine that's in is a relatively easy and cheap fix so I don't need to go as far as swaping over

Rev 3

Mmmmmmm engine isn't in a car at the moment :D Briefly, I have a complete car that I'm told has a knock, it's either a rev1/2. http://i1294.photobucket.com/albums/b615/macca_172/c42fe79a63e1dd887224fa01bc6583f3_zpse2e93621.jpg If the repair is to costly I have the rev3 engine as a possible swap, but...

Injectors are brown, not sure what they should be, there is an adjustable FPR also? http://i1294.photobucket.com/albums/b615/macca_172/ef1401e4e8a3aed85ed72397501c8674_zps4d639ddb.jpg Engine mounts are TRD and the flywheel doesn't look standard, I can see a number of Allen bolt heads on the block si...

http://i1294.photobucket.com/albums/b615/macca_172/86798c4a4739fda856e2c7724b3d0555_zps19221f0f.jpg I have a Rev 3 (I think) non standard engine that has never ran since coming in from Japan, the ecu had been removed from the car before it landed here. I know it's had some mods but as yet don't kno...

Peter Gidden - SBITS wrote:Exhaust I'd what?

Like for Christmas?

Hate to have on my car?

I'd like to know if it's any good and is it better than my other one........
Twin exit with "departure" stamped on it!

Thanks

[/img]

Any ideas on which exhaust this is?
Thanks

They did quite a lot circa 2007-2011?

[/img]

Not the best pic but all I have at the moment 😉

Cheers

Without going in to all the details I was hoping to gauge interest in the possibility of bringing MRD body kits back to the market. These would be genuine items from MRD's moulds, built by their supplier and with full MRD support. I fully understand pricing will be a big influence, and this has yet ...