I was looking at the pdf a while ago on the Knowledge Base and tried to go onto the site yesterday, but got an HTTP 404 error?? Unable to access the .pdf document.
Bill W
[Mk2] [NA] 1999 MR2 Mk2 SW20 Aerial PDF
Moderators: IMOC Moderators, IMOC Committee Members
1999 MR2 Mk2 SW20 Aerial PDF
That's the one Nic, many thanks for your help. Bill W.
1999 MR2 Mk2 SW20 Aerial
Just fitted an aerial to my MR2, that I bought form Jamitsi a member on this site. I have now found out that there are at least 3 versions of the wiring of these aerials to the aerial relay box attached to the aerial. In the knowledge base, there are 8 connections numbered 1 to 9, with No7 not used, 8 wires connected. On the 1994 one I bought from Jamitsi, the connections are, 1 to 8 with all 8 pins used. On the 1999 one I took off the pins are numbered 1 to 8 and only 7 used. The Red with a White stripe isn't there as it was with the 1994 aerial. As I knew that the motor on mine worked, I just swapped the wiring harness with the 3 connectors from my old 1999 aerial to the 1994 one fitted the aerial and it worked fine.
Happy but confused!!!
In the cct diagram in the knowledge base the Red/White pin 8 connection is used as a +ve to raise the aerial and it stays raised until this pin goes to 0v.
If anyone knows why I would be interested Thanks Bill W.
Happy but confused!!!
In the cct diagram in the knowledge base the Red/White pin 8 connection is used as a +ve to raise the aerial and it stays raised until this pin goes to 0v.
If anyone knows why I would be interested Thanks Bill W.