I know this has been done a 1000 times but I'm considering the above swap.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
ENGINE LOOM
AFM
TURBO
COIL PACK
WALBRO FUEL PUMP
INTER COOLER
PIPE WORK
ECU
![](./images/smilies/spacer.gif)
SUB FRAME
DRIVE SHAFTS
REAR BRAKES
BLISTEIN SUSPENSION
EXHAUST
![](./images/smilies/spacer.gif)
Is there anything else I need? I will be servicing the engine before it goes in with new plugs, belts, leads, filters etc and am hoping to do it in under a week.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Any ideas how long it takes to remove an engine for an SW20?
![](./images/smilies/spacer.gif)
Things I should look out for?
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I have seen the how to thread that gets posted around which is helpful but is a rev2 to rev2 swap so I'm assuming there are minor differences!
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Will the loom be plug and play into the passenger footwell? This is another query I have.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Cheers Ben