![Sad :(](./images/smilies/icon_sad.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![Sad :(](./images/smilies/icon_sad.gif)
Moderators: IMOC Moderators, IMOC Committee Members
Peter Gidden - SBITS wrote:All the 3S-GTE forged pistons i've seen(and i've seen a lot of them!), have a cut out for the squirter.
Have you got them in the right way round?
fishface wrote:Peter Gidden - SBITS wrote:All the 3S-GTE forged pistons i've seen(and i've seen a lot of them!), have a cut out for the squirter.
Have you got them in the right way round?
I have the largest cut outs in the crown on the left as you look at it from the cambelt end which i assume is right Peter?
Peter Gidden - SBITS wrote:
Correct.
But as i and Ash have asked, have you got cutouts in the pistons?
ashman wrote:Interesting- I've not seen that design of skirt before..
.
You may need to modify your oil squirters slightly to accomodate the pistons, it looks like you've got room to rotate the nozzle round a bit and create some clearance