[Mk2] [Turbo] mr2 turbo rev2 convert to rev 3 fuel system and ECU HELP!!!

[zaid_mohamed]

Mr2 turbo rev2 convert to rev 3 fuel system and ECU HELP ME!!!

I need some help...can any advise me a good place to get my mr2 turbo rev2 converted to rev 3 fuel system ?

dont want to spend mad money but reasonable amount is ok.

i have most of the bits for conversion apart from the a rev 3 turbo ecu/engine loom, rev 3 turbo fuel pump resistor and the coil for the rev turbo igniter. far as im aware know i may not need the loom as re-pining the ecu will be and option, same goes as the fuel pump resistor and the coil those can be reused from my Rev2 tubro? im unsure tho?

anyways need to know if any 1 can do the job. or can any member who done it before help me and guide me so i can do it my self. or even better some around London area take time out to give me hand?

these are all the Rev3 turbo item i have

Map sensor
IAT sensor
MAT sensor
4 wire o2 sensor
water temp sensor
Knock sensor
Igniter(with out coil, but im not sure if my rev 2 turbo coil is fine to re-use)
Injectors
Power fc ecu + commander
ST205 Ecu (back up)
Walbro 255 fuel pump

As of now these are the mods the car has got.
Forged pistons
cometic head gasket
ARP head bolts
Turbo Technics stage 1 hybrid turbo
Greddy SMIC
Full Japspeed exsuast system and de-cat down pipe
Induction kit
Greddy boost controller

Please help me convert my car and make me faster !!!!!!!!

[Peter Gidden]

Where in the UK are you?

[zaid_mohamed]

Im based In Heston. I live very close to to Heston services.
west London area faily close to Heathrow airport if that help.

[alanmr2turbo]

you say you are thinking of repinnig the REV2 engine loom to fit the ECU?

If that the case you only need

Map sensor
IAT sensor
MAT sensor
Igniter
Injectors
Power fc ecu + commander


ST205 Ecu (back up) (will throw up charger cooler errors)
Walbro 255 fuel pump

You also ether going to make or buy a converter plate for when you take out the cold injector to replace it with the IAT sensor.

[zaid_mohamed]

Oh crap i dont have Mat plate? doh! crap i need to get one, but i have seen some on ebay. very easy to get hold of so thats good.

st205 ecu is only for time being(A week at max) its just for when im taking my car to tuners to get my power fc mapped after that it will be just as a back up ecu. i dont want to use base power fc map coz i herd its crap.

i want to get fuel 255 fuel pump fitted coz if want to get even want bigger injectors later on and feel the need of more power. at least i know that one job is done.

I dont mind re-pining it Unless i can get a rev3 turbo loom.

anyways the i need help to fit this stuff??? recommend me a place to fit this!

does any 1 have a REV3 TURBO LOOM?????? if not il just hav to settle for the reping route?

[zaid_mohamed]

Ended up going to luke at pacific works! this guy know his mr2s the same way senna knew F1 cars! legend!!