dual port actuator?? and where have you fitted your ebc?

redmr89 · Post by **redmr89** » Mon Jul 13, 2009 6:52 pm

just about to fit my ebc and the instructions mention a single port or dual port actuator. which one do i have? its a ct20b.

and for all the pic whores out there, can i see pics of where youve put your ebc?

cheers.

MRGEN3TURBO · Post by **MRGEN3TURBO** » Tue Jul 14, 2009 9:38 am

Its a dual port, remove and block the second one that goes to the factory boost controller at both ends (I used a 10mm bolt and a hose clamp) and run the second port to your ebc. You can use either port, they are both the same.

Dont have a pic but I mounted mine using an existing bolt hole on the firewall on the air intake side. Planning on moving it though as a fair bit of noise from the soleniod it transmitted in the cabin.[/list]

redmr89 · Post by **redmr89** » Tue Jul 14, 2009 11:08 am

cheers . i thought it was. just needed confirmation.

anyone got any pics of theres? particularly the control unit in the cabin.

MRGEN3TURBO · Post by **MRGEN3TURBO** » Wed Jul 15, 2009 12:05 am

Heres where I put mine, in the centre storage console out of the way of prying eyes and the fuzz

redmr89 · Post by **redmr89** » Wed Jul 15, 2009 12:08 am

i was thinking of putting mine there but its hard to access it while driving.. ie selecting high and low boost...

Quigonjay · Post by **Quigonjay** » Wed Jul 15, 2009 6:35 am

you can get a steering wheel mounted switch for switching between high and low

redmr89 · Post by **redmr89** » Wed Jul 15, 2009 3:23 pm

you can get a steering wheel mounted switch for switching between high and low

ive never seen one before.. any ideas on cost?

nailmonkey · Post by **nailmonkey** » Wed Jul 15, 2009 9:09 pm

Just leave it on high and use your right foot to control the boost!

Nik

redmr89 · Post by **redmr89** » Wed Jul 15, 2009 11:20 pm

lol. i knew someone would say that..

www.imoc.co.uk

dual port actuator?? and where have you fitted your ebc?

dual port actuator?? and where have you fitted your ebc?

Re: dual port actuator?? and where have you fitted your ebc?

Re: dual port actuator?? and where have you fitted your ebc?

Re: dual port actuator?? and where have you fitted your ebc?

Re: dual port actuator?? and where have you fitted your ebc?

Re: dual port actuator?? and where have you fitted your ebc?

Re: dual port actuator?? and where have you fitted your ebc?

Re: dual port actuator?? and where have you fitted your ebc?

Re: dual port actuator?? and where have you fitted your ebc?