www.imoc.co.uk

think i'll have a look round the scrappers to get the best condition 1 i can. its a good point for the cost of a sump pan i could get a new engine!

Thats not too bad i'll call in this week. Is there anywhere else that will do them?

Cheers pal but ideally new unless there mega bucks. Forgot to say its a rev2 na. will a rev3 fit? I'll pm you if i can't source one. Ta

In need of replacing my sump pan as its corroding. Any1 know where i can buy one other than toyota which will prob be expensive??

rev2 na

does your stereo have a red and yellow wire with push connectors? If so swap the wires over red to yellow and vice versa.

Im in bacup near rochdale. yeah have seen about denting rear panel. will have to look for a lock. Been in touch with the guy i bought them from to see if he has the brackets so just waiting for him to get back to me. Cheers for your advise everyone

sorry should have put its a rev2 and ive bought rev3 setup but no brackets. Are these easy to find? knowing my luck probably not

Hi all just bought rev3 rear lights and centre panel. Question is do i need some brackets to fit the centre? Or do i take them off the old panel?

Ha had that prob b4 an my rs turbo, horn went every time a turned a corner

Its off

Finally damn it was hard. Worst thing is i had to put it back on as i couldnt work out the horn lol

I will take soon pics soon to see if anyone can point me in the right direction

Will tackle it tomorrow with all the tips from you guys cheers

Its is only the nut that holds it on? pulled wiggled even tried a crow bar but just broke a piece of plastic off my steering coloum.

Hi all new to the mr2 world ,great site

Anyway tried today to take my steering wheel off must have spent a good 4 hours before i gave up.(sore arms)

Is there a trick to it?