A quick check on offset

[billy]

Hi,
I have found some alloys that I would like to fit to my Rev 1, but I would like to run the size by the gurus on the site before I willy it up....

Front - 17inch 7.5 wide, 215.40.17 offset 35
Rear - 17inch 7.5 wide, 235.40.17 offset 35

It is the offset that I was not sure about...will these fit OK or will I need any spacers or anything?

Thanks a lot for any advice....

They are ROTA Battle alloys by the way.

[Andy Jones]

Hi Billy, They'll fit

Running the same width's & offset on mine. On rare occasions (very bad dip in road) the fronts do scrub against the plastic arch lining, But it is lowered 50mm

[billy]

Hi Andy,
Thanks very much for the reply.
That means I can order them with peace of mind.
Appreciate that a lot!

Regards

Billy