got my baby back :)

[simpson_eh]

just had my baby dropped off this morning been so long

had 5sgte dropped in just because i wanted it lol

rev 3 head with a forged 2.2 camry bottom end and new box with extended final drive, gt3071r

now to get it mapped by the magic of ryan


oh and a mot tomorrow
not the best photos due to angle and light, excuse the pic of bay its a state and needs tidying lol

[2mad]

Awesome looking car with an equally hardcore engine setup , nitrous too nice

Looking forward to the mapping results

[slipping clutch]

just had my baby dropped off this morning been so long

had 5sgte dropped in just because i wanted it lol

rev 3 head with a forged 2.2 camry bottom end and new box with extended final drive, gt3071r

now to get it mapped by the magic of ryan


oh and a mot tomorrow
not the best photos due to angle and light, excuse the pic of bay its a state and needs tidying lol



Love it and your honesty - "had 5sgte dropped in just because I wanted it"

[simpson_eh]

if the other half found out how much it cost she would kill me lol, i had a forged rev 3 block taken out to put this in

[MR2 Turbo Boy]

if the other half found out how much it cost she would kill me lol, i had a forged rev 3 block taken out to put this in

Same as me bud,....

5sgte dropped in, remap by Ryan tomorrow, looking for around 600bhp..

I'll keep you posted..

[craig]

Car looks great, beast!

My car is currently off road awaiting a new forged engine. Makes me want my car back, run in and mapped now!

Such a wait ahead of me.

[simpson_eh]

passed my mot but got advisories on all four tyres lol every year its always tyres

[simpson_eh]

so finally my mapping session rolls around tomorrow, hoping for 500 but realistacally with my turbo 450 fingers crossed

turbo boy what did you manage out of yours after

[mr2toby]

What figures did get at your mapping session ?

[simpson_eh]

none mid range power good but just drops dead at 5k wont go over 340

[mr2toby]

That's a shame. What was your peak intake temperature ? I don't think the st205 charge cooler will flow much past 390 ish.

[simpson_eh]

ryan said they are good for 500 but the 3071 is only good for 430 anyway, my issue was the piston rings and something in the head like a unseated valve
contaminated fuel causing knock at high rpm
oh well more money on the two

new rings( purchased bottom end already built) and check the head over and drop some 264 in there

[jimGTS]

So going back to a 2ltr?

I cant imagine there are many already built 2.2 bottom ends for sale!

What were the intake temps?
Didn't think the st205 cc was good for much past 360. Could be wrong.

[simpson_eh]

il just strip this one and check bores replace rings and drop a set of 264 cams and rebuild the head hopefully that will sort it out

the engine runs absolutely fine and is driven daily just anything over 5/6k is a no go , so i can take my time, nice having low down power and faster spool from the 2.2 though and now its not running on the old map might save some fuel lol