[Mk2] [Turbo] How to wire in a digital boost gauge?
Moderators: IMOC Moderators, IMOC Committee Members
[Mk2] [Turbo] How to wire in a digital boost gauge?
The instructions that I have received are not that clear??
Re: [Mk2] [Turbo] How to wire in a digital boost gauge?
this will all depend on the digital gauge 
in question
You are better off contacting the retailer!
Basically-
* you will have wires from the gauge to the sensor - that should be obvious
* you will have Power wires to the gauge, these should be from an Ignition Switched Source (the Cig Lighter should to)
* you will have an Illumination input - will also be found by the Cig Lighter.
You will then require a Multimeter(Volt Meter) to work out which Toyota wire is which.
Personally, I recommend Soldering all wire connections.
Paul
in questionYou are better off contacting the retailer!
Basically
- * you will have wires from the gauge to the sensor - that should be obvious* you will have Power wires to the gauge, these should be from an Ignition Switched Source (the Cig Lighter should to)* you will have an Illumination input - will also be found by the Cig Lighter.You will then require a Multimeter
(Volt Meter) to work out which Toyota wire is which.Personally, I recommend Soldering all wire connections.
Paul