IS200 ABS sensors
Moderators: IMOC Moderators, IMOC Committee Members
IS200 ABS sensors
Evening chaps, so I've got a duff right rear sensor and I've heard it mentioned a few times now so I'm just wondering if anyone here successfully used the IS200 ABS sensors on their MR2? How was the fit? How much modification was needed?
Re: IS200 ABS sensors
IIRC it's the front ones that fit, not the back ones? Not 100% sure.![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Re: IS200 ABS sensors
Kirk, if you decide to go ahead and try this, would you take a few photos of the original and the IS200 fitted.![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Re: IS200 ABS sensors
In that case then I shall invest in a fully functioning used one to test the theory on my bad sensor.
I'll report my findings
![thumleft :thumleft:](./images/smilies/icon_thumleft.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![thumleft :thumleft:](./images/smilies/icon_thumleft.gif)
Re: IS200 ABS sensors
Kirk would you measure the length and diameter of the original sensor i.e.
the part that slots inside the hub.![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Re: IS200 ABS sensors
I can do that.
Won't be for a few weeks yet like.![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Re: IS200 ABS sensors
Kirk, I have been reading conflicting reports about people extending their ABS sensor cables with success
(off-roading jeeps mainly).
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I was thinking that if you do get a IS200 sensor and it is the correct size for the rear hub, then you may want to extend it.
Test it first if you do go down that route.![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I think the MR2 SW20 sensors are so expensive is because of the extra hardware used to bolt it on.
I suppose they may not have been produced for any other vehicle
, which increased cost.
Who knows?
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I was thinking that if you do get a IS200 sensor and it is the correct size for the rear hub, then you may want to extend it.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I think the MR2 SW20 sensors are so expensive is because of the extra hardware used to bolt it on.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)