I have a pair of GSC Stage 1 camshafts for sale, as used by ATS in the vast majority of their builds. These are suitable for all revisions of the 3SGTE, but were designed for the rev 1/2 engine...although ATS use them for all revisions (means they are safe to use with shim-over-bucket followers).
268 degree duration, 9.9mm lift on both inlet and exhaust.
These have covered no miles, and have only actually run in my engine for about 5 minutes...I had a clearance issue and the inlet cam bound up on no1 journal. I have now had this journal on the cam polished, and it is well within tolerance and good to go.
To purchase these new from ATS you are looking at:
$569 - Camshafts
$100 - Shipping
$134 - VAT
$36 - Duty
£580 total.
Will sell for £300 + postage.
Perfect cams for a nice road warriar spec MR2, maintaining lots of low-mid range grunt, with the ability to run to 8k+ rpm if required.
Selling as I was impatient with my build, so used new replacements as I waited for the journal to be polished on this set.
[FINALIZED] GSC Gen2 Stage 1 Camshafts
Moderators: IMOC Moderators, IMOC Committee Members
-
- Posts: 6071
- Joined: Wed Dec 15, 2004 10:16 am
Re: [FINALIZED] GSC Gen2 Stage 1 Camshafts
This Sale has been completed. The Buyer was J-1