Just a quick question,
When converting a rev2 to rev3 lights should the centre panel sit flush with the boot as my boot overhangs by 1/4 inch or so?
[Mk2] [NA] Rev3 light conversion
Moderators: IMOC Moderators, IMOC Committee Members
-
- IMOC Affiliated Trackday Organiser
- Posts: 10506
- Joined: Tue Jan 25, 2005 9:49 am
- Location: South Yorkshire
Re: [Mk2] [NA] Rev3 light conversion
Have you bashed in the rear panel to clear the reverse lights?
Re: [Mk2] [NA] Rev3 light conversion
Should look like this:
Re: [Mk2] [NA] Rev3 light conversion
Yeah bashed it to clear the reverse lights. When looking down from the top the panel does not sit flush with the lip of the boot.
Re: [Mk2] [NA] Rev3 light conversion
cavegod wrote:Yeah bashed it to clear the reverse lights. When looking down from the top the panel does not sit flush with the lip of the boot.
Sounds like the reverse light housings are still conflicting with the bodywork, thus pushing the panel out.
Re: [Mk2] [NA] Rev3 light conversion
If anything if they pushed it out it would line up better.
Ill take a pic.
Ill take a pic.