Crystal clear headlight

[Mr Bognor]

I have the below to fit but this is just the head light with a rubber back .

Does it have all the clips inside the rubber on the back or do you need to chop this off your old light unit ???

http://www.ebay.co.uk/itm/171260266899? ... 1497.l2649

[mr2matt]

These are the same one's I bought.

The retaining clip is universal, although slightly different in design it still works the same, the rubber bit I took off and swapped for the existing stock one's as they have the correct cut out and air pipe to stop the headlight fogging up. And yes the clip is underneath the rubber cover.

When will you be fitting them as I can take mine off later and post some pictures if you would like.

[Mr Bognor]

Will have a go Saturday mate .

Looks like it will be easy ish i just was unsure if you had to take the clip and lamp holder from the old unit .

Thanks

Alan

These are the same one's I bought.

The retaining clip is universal, although slightly different in design it still works the same, the rubber bit I took off and swapped for the existing stock one's as they have the correct cut out and air pipe to stop the headlight fogging up. And yes the clip is underneath the rubber cover.

When will you be fitting them as I can take mine off later and post some pictures if you would like.

[RikH77]

really easy, as Matt says swop over the rubber covers with the air vent on as its a better design from the OE lamps

[Mr Bognor]

I take it there is no lamp cover to put over the bulb then ?

Alan

[RikH77]

no, the cap of the bulb itself does that job

[Mr Bognor]

none