![](./images/smilies/spacer.gif)
So it took me a while to realise I needed to rewire one of the cables in my loom to get rid of this terrible buzzing sound, and that I needed to use the
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
It's all functioning well, but the sound quality is pretty rubbish.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
which im not prepared to do just yet because I don't have the funds
![](./images/smilies/spacer.gif)
I think part of the problem is that I only have one set of preouts on my headunit.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
now I think the rca splitters are making the low frequencies route to the front tweeters
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
so I bit the bullet and got a headunit today with 3 x pre outs
Front, Rear and Sub
![](./images/smilies/spacer.gif)
so i'm wondering how best to connect this up?
should I use the sub out? or just the front and rear outs
![](./images/smilies/spacer.gif)
i listen to quite a lot of bassy music, so i was gona try
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
thought i'd ask
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
thanks in advance