1994 rev 3 heater control valve cable

[Blue_2]

Hey

The cable that controls my heater control valve has jammed stuck, so only get cold air at the moment.

Guess iam going to need a new one, does anyone know the part number for it?

Also is it a big job to replace? any how to's?

Cheers for reading

[Peter Gidden]

Don't buy a new one, plenty of good s/h units around. Easy enough to replace.

Before you go dismantling, just unhook the cable from the heater valve under the frunk, and move the heater valve lever by hand to ensure it's not a valve issue.

[Blue_2]

Hey Peter

yer i did that already valve moves nice and freely but at the valve end the cable wont move

i take it to get to the cable its a case of taking the dash apart?

[Blue_2]

Does anyone know if you can get to the other end of this cable without removing the dash?

[Peter Gidden]

You will have to remove the ashtray and centre dash panel. Then you can unscrew the heater control panel and pull it forwards to get at the cable end.

[Blue_2]

cheers Peter.

[MR2 Rich]

I had this and it turned out that there were some cables stopping it from moving.