[Mk2] [Turbo] Toad ai606

[Pidge]

I have a toad ai606 and have fitted it to three different cars now and got certificates for them but I'm at a loss with the wiring on an mr2.

Is there anyone local to me with an ai606 fitted that I could have a look at some time so I know what colour wires the fuel cut etc are.

I have already run the prox box, microwave sensors, 3 open switches and remote start but it's the central locking, fuel and ignition cut wires I am at a loss with.

Any help will be much appreciated

[Pidge]

Nobody?

[madbasshunter]

Here you go
Toyota MR2 SW20: (1989-1999)
Siren Location - N/s bulkhead
Harness Entry - Spare grommet in n/s bulkhead
Permanent Supply - Heavy black/red wire in main harness (also heavy white) behind n/s seat back
Ignition Supply - Black/yellow wire located in main harness
Starter Immobilisation - Heavy black/white wire located in main harness
Ignition Immobilisation - Black/yellow wire in loom to electronics ignition
Fuel Pump Immobilisation - Blue/black wire at rear of passenger seat
Hazards - To green/black and green/yellow wire in main harness
Door switches - Red/white wire in multiplug at o/s/f kickpanel. Common switched neg.
Boot/tailgate switch - At lamp position
Bonnet Switch - Fit switch
Central Locking - Negative Central Locking

Lock - Thin black wire in o/s/f door harness
Unlock - Thin black/yellow wire in o/s/f door harness
Window Closure - Positive up
o/s/f - Red at motor in o/s/f door
n/s/f - Red/blue in door loom to o/s/f kickpanel

[Pidge]

Awesome work mate and much appreciated! If this wind dies down I might give it a go in a bit

Thanks!