[Mk2] [Turbo] Anybody know a MR2 turbo engine wiring loom back to front?

Anything to do with the electrics of the car.

Moderators: IMOC Moderators, IMOC Committee Members

Post Reply
theonetowatch
Posts: 43
Joined: Mon Jan 10, 2005 5:34 pm
Location: Bracknell

[Mk2] [Turbo] Anybody know a MR2 turbo engine wiring loom back to front?

Post by theonetowatch »

Ok nobody laugh. I took my MR2 apart 2.5 years ago and I am finally putting it back together. In that time I've lost my manual on CD and being tight wouldn't buy another one. Everything went back together really well apart from a little loom issue. I have a brown single spade connector left over and 3 large earthing terminals, gearbox side of the engine. Any ideas where they go?
Any input appreciated
Regards
Alan
Top
theonetowatch
Posts: 43
Joined: Mon Jan 10, 2005 5:34 pm
Location: Bracknell

Re: [Mk2] [Turbo] Anybody know a MR2 turbo engine wiring loom back to front?

Post by theonetowatch »

Its got a black wire with a white trace going to it and it branches off the loom with an earthing ring terminal. I have tried looking at the PDF sticky and can find it on the loom run diagram on the enigine but cant find the colour combination on the engine sensor ip/op schematic with that wire colour.
Al
Top
theonetowatch
Posts: 43
Joined: Mon Jan 10, 2005 5:34 pm
Location: Bracknell

Re: [Mk2] [Turbo] Anybody know a MR2 turbo engine wiring loom back to front?

Post by theonetowatch »

Ok I found where the plug goes thanks to the sunshine. on the starter motor there is a ring terminal that branches off with it. doesn't seem to go to ground are there two that go on the starter motor?
Top
theonetowatch
Posts: 43
Joined: Mon Jan 10, 2005 5:34 pm
Location: Bracknell

Re: [Mk2] [Turbo] Anybody know a MR2 turbo engine wiring loom back to front?

Post by theonetowatch »

heavy gauge ground that goes from gearbox bell housing to somewhere?
Top
Post Reply

Return to “Electrical”