These are suitable for all revisions of the 3SGTE, but were designed for the rev 1/2 engine...although ATS use them for all revisions (means they are safe to use with shim-over-bucket followers).268 degree duration, 9.9mm lift on both inlet and exhaust.
These have covered no miles, and have only actually run in my engine for about 5 minutes.
..I had a clearance issue and the inlet cam bound up on no1 journal. I have now had this journal on the cam polished, and it is well within tolerance and good to go.To purchase these new from ATS you are looking at:
$569 - Camshafts$100 - Shipping$134 - VAT$36 - Duty£580 total.Will sell for
£300 + postage.Perfect cams for a nice road warriar spec MR2, maintaining lots of low-mid range grunt, with the ability to run to 8k+ rpm if required.
Selling as I was impatient with my build, so used new replacements as I waited for the journal to be polished on this set.