[Mk2] [Turbo] apexi power fc

[blogsy]

hi all, i have tried searching for a answer to this on the site, and i have done a bit of googling. but i cant seem to find a answer. how do you tell if an apexi fc is for a rev2 or for a rev3. this is the serial number of the one i am trying to identify: pfc sw20 9906-0011. thanks .

[chron]

bit of googling myself there and it seems to say that number 9906-0011 is for a RX8?

[Magic Beans]

I can't tell you for sure if it's a rev2 or rev3 version, if there's even a difference to be honest

However this might help you http://www.paulr33.com/powerfc-faq/powerfc-faq.htm#89

[Peter Gidden]

IIRC, Apexi did not make a PowerFC specifically for the MR2 Rev1/2, only Rev3/5.

Rev1/2 PowerFCs were modified by A.P. Engineering and carry an A.P. Engineering logo.

[Magic Beans]

There's an AP one for sale in the classifieds too, if you needed one

[toyokid]

I have a rev 2 AP Engineering version of the Power fc for sale.

Stephen

[toyokid]

This ecu will plug straight into a rev 2 and run with the AFM fitted
and only requires a map sensor (circa £75 from gtschris) and an inlet air temp sensor, circa £30 to run without the afm (recommended).

Stephen