[Mk2] [Turbo] Berk Rev2 to Rev3 ECU harness -???

[JasonB]

Just seen this on ebay;
http://www.ebay.co.uk/itm/Berk-USDM-JDM ... 43af83882e

Anyone seen anything like this before?
Is this all that's needed to get a rev 3 ecu or Power FC working on a rev. 2?
No igniter etc that is normally needed? Also could you do away with the MAF?
Ignoring the fact that it'll cost you more in postage than it takes to buy the thing I'm quite interested in this.
If anyone has any info then I'd be greatful.
Cheers.

[toxo]

No, you would still need all the ancilliaries that the rev3 ECU expects to be there. This just allows you to run the ECU without modifying your existing wiring loom.

[Race Idiot]

Ive actualy got one of these knocking around that I never used ages ago on my rev2 motor. However they left it unpinned so that you could configure it for jdm or uk cars.

[Peter Gidden]

$145 shipping?? Complete thieves! Wouldn't dream of buying from them.

Go to Berk instead:

http://www.berktechnology.com/store/sto ... ectronics/

[Race Idiot]

Coulda sworn it only cost 40 squid or so a few years back