Hi chaps
I need to get a pair of wheel spacers to sort an issue with my front wheels not quite lining up with the trd body kit. I have found these http://www.wheels.uk.com/acatalog/wheel ... tem-5.html
but it says "Please state the present wheel bolts (Taper or ball seating),when ordering" and I'm not sure which I should specify. They are to go onto a normal rev2 hub. Does anyone know which I should spicify?
Thanks!!
It is refering to the seat of the nuts used on your after market rims. The majority use taper (ball seat/radius are used by VW, Seat, Audi, Skoda, Porsche on factory fitted wheels) Take one of your wheel nuts off and check the seat, It should either be a straight 60 degree line (taper) or curved (radius/ball seat) If your uncertain throw up a piccy and i'll confirm which one it is.
EDIT: "borrowed" this pic from another website to explain better
Engine rebuilt by: Steve Horrocks & Andy Jones Engine mapped by: Ryan@2bartuning (330 bhp & 325 lbft @ 1.4 bar) Current Status: F****D
Thanks Andy, brilliant information there. I didn't think anyone was gonng help me on this one. I will check my nuts against the pic you've attached. Much appreciated