![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
do i have to remove the TRC to change my plugs? or is the a way to do it with it still in?
if i have to remove the TRC is it easyto remove/replace? and how do i do it?
Moderators: IMOC Moderators, IMOC Committee Members
simmo490 wrote:all you need to take off mate is the soft pipe between the IC pipe and the TB, undo the clips and slide it off.
this way you can get the ht leads off and get to the plugs
simmo490 wrote:yeh mate, i have been having my plugs in and out quite allot recently and thats all i have been doing, didnt even have to unbolt the HT lead rail(would make it easier though)
Rogue wrote:
But according to the photo in your profile, you don't have TRC installed.
You WILL need to remove the TRC butterfly section to get to the plugs.
Regards,
Patrick
KyzarVS wrote:On my Rev2 the TC unit is held on with 4 bolts(13mm socket from memory)
iwantoneofthose wrote:o right ok is it a difficult job to do or just undo bolts etc then remove and bolt back on after??
Rogue wrote:
Just remove and refit.For those that have't seen traction control, here it
on a revision 3 engine:
Regards,
Patrick