![](./images/smilies/spacer.gif)
[quote="Adam86"]Unfortunately I believe the block to be cracked.
![](./images/smilies/spacer.gif)
Covered 2500
![](./images/smilies/spacer.gif)
- 3000 miles since complete rebuild with the following parts
86mm Forged Wosner pistions 8.0-1
![](./images/smilies/spacer.gif)
ACL bearings throughout
![](./images/smilies/spacer.gif)
New cam belt and bearings
New oil and water pump
New gaskets and seals throughout
![](./images/smilies/spacer.gif)
Asking for
![](./images/smilies/spacer.gif)
£500 which is less than the pistons alone cost.
![](./images/smilies/spacer.gif)
With the oil and water pumps removed I'll take
![](./images/smilies/spacer.gif)
£400.
![](./images/smilies/spacer.gif)
I also have a rev2 block with 86mm bores to suit the wosner pistons as I was going to re-block the engine before I decided to go with a caldina 3sgte.
![](./images/smilies/spacer.gif)
Not wanting to be negative but I just dont get this add?
![](./images/smilies/spacer.gif)
Your selling a forged block, but the blocks cracked,
![](./images/smilies/spacer.gif)
Your selling ACL bearings but I would never re-use bearings especially if they have to go into another block.
![](./images/smilies/spacer.gif)
Then you say this is less than the price of new pistons, well yes second hand pistons would most definitely be less than the price of new ones.
![](./images/smilies/spacer.gif)
Gaskets
![](./images/smilies/spacer.gif)
& seals arnt really re-usable in a high performance engine
![](./images/smilies/spacer.gif)
Genuine question am i missing something
![](./images/smilies/spacer.gif)
Kennym