Quick updated, Its been pretty boring stuff so I'll upload some before and after photo's
![](./images/smilies/spacer.gif)
**Interior has was fully removed**
![](./images/smilies/spacer.gif)
Dashboard removed, all wiring addressed,
![](./images/smilies/spacer.gif)
(converted back to stock and correct wire colours used
![](./images/smilies/spacer.gif)
(from a donor loom)
![](./images/smilies/spacer.gif)
Central Locking fixed finally
![](./images/smilies/spacer.gif)
(turns out it was the aftermarket alarm controller)
![](./images/smilies/spacer.gif)
Centre console converted to take 3 52mm defi gauges
![](./images/smilies/spacer.gif)
(water temp, oil temp, oil pressure)
![](./images/smilies/spacer.gif)
Relocated boost controller, also relocated the boost controller ECU box
![](./images/smilies/spacer.gif)
aem wideband removed replaced for Innovate one
![](./images/smilies/spacer.gif)
All trim plastics replaced for very clean ones
![](./images/smilies/spacer.gif)
another set of clocks due to rev gauge/speedo failure
![](./images/smilies/spacer.gif)
(leaking caps)
![](./images/smilies/spacer.gif)
Omri Boost gauge added to cluster
![](./images/smilies/spacer.gif)
Leather door cards
![](./images/smilies/spacer.gif)
aftermarket fog lights removed, replaced for factory, Also need to finish off the wiring loom for this since this was butchered for the other lights
![](./images/smilies/spacer.gif)
:/
![](./images/smilies/spacer.gif)
new seat rails/frames for the corba seats
![](./images/smilies/spacer.gif)
(came with old homebrew job was making them sit a little high)
![](./images/smilies/spacer.gif)
engine bay loom tuck
![](./images/smilies/spacer.gif)
Pop lights deleted replaced with twin fixed lamps.
![](./images/smilies/spacer.gif)
all Carpets replaced
![](./images/smilies/spacer.gif)
Run brand new speaker cables, removed the factory ones
![](./images/smilies/spacer.gif)
(also the common mods for getting larger speakers in the standard mounts)
![](./images/smilies/spacer.gif)
Also some wheel spacers for the new rims
![](./images/smilies/spacer.gif)
(front 8mm)
![](./images/smilies/spacer.gif)
Hoping by the end of next week should be ready to try and fire it back up.
![](./images/smilies/spacer.gif)
however need to get these things sorted first.
![](./images/smilies/spacer.gif)
Probs loads more things ive done, just felt like the last month has been chasing crazy DIY wiring around the car.
![](./images/smilies/spacer.gif)
new ECU needs pinning into the loom
need to connect the braided fuel line
walbro pump needs installing
finish off the VAC lines now the cab's sorted.
![](./images/smilies/spacer.gif)
needs its MOT renewing, wow that was a fast 12 months car only saw 600 miles on the road this year
![](./images/smilies/spacer.gif)
:<