Quick updated, Its been pretty boring stuff so I'll upload some before and after photo's
**Interior has was fully removed**
Dashboard removed, all wiring addressed,
(converted back to stock and correct wire colours used
(from a donor loom)
Central Locking fixed finally
(turns out it was the aftermarket alarm controller)
Centre console converted to take 3 52mm defi gauges
(water temp, oil temp, oil pressure)
Relocated boost controller, also relocated the boost controller ECU box
aem wideband removed replaced for Innovate one
All trim plastics replaced for very clean ones
another set of clocks due to rev gauge/speedo failure
(leaking caps)
Omri Boost gauge added to cluster
Leather door cards
aftermarket fog lights removed, replaced for factory, Also need to finish off the wiring loom for this since this was butchered for the other lights
:/
new seat rails/frames for the corba seats
(came with old homebrew job was making them sit a little high)
engine bay loom tuck
Pop lights deleted replaced with twin fixed lamps.
all Carpets replaced
Run brand new speaker cables, removed the factory ones
(also the common mods for getting larger speakers in the standard mounts)
Also some wheel spacers for the new rims
(front 8mm)
Hoping by the end of next week should be ready to try and fire it back up.
however need to get these things sorted first.
Probs loads more things ive done, just felt like the last month has been chasing crazy DIY wiring around the car.
new ECU needs pinning into the loom
need to connect the braided fuel line
walbro pump needs installing
finish off the VAC lines now the cab's sorted.
needs its MOT renewing, wow that was a fast 12 months car only saw 600 miles on the road this year
:<