Hi Guys,
I am wondering if you lot can help me out. I have a rev 3 inlet and throttle body and acis spacer to put on my rev 2. I am looking for some help in making it fit.
It has been sitting in my garage for too long and I need to get it on and thought I would ask here before I butcher it up
How much modification is needed to the rev 3 inlet to make it fit properly??
Cheers
[Mk2] [NA] Rev 2 to rev 3 inlet conversion N/A
Moderators: IMOC Moderators, IMOC Committee Members
-
- Posts: 1
- Joined: Sun Jan 18, 2015 6:51 pm
- Location: Derby, East Midlands
-
- Posts: 571
- Joined: Wed Nov 06, 2013 9:10 pm
Re: [Mk2] [NA] Rev 2 to rev 3 inlet conversion N/A
I was in a similar situation before and to my knowledge the Rev 3 inlet will not bolt onto the rev2 head so the only way to do it would be to change the whole head.
Re: [Mk2] [NA] Rev 2 to rev 3 inlet conversion N/A
No, it is possible to achieve, ask Jeff Trump on the MR2OC facebook page. Involved a bit of fettling and die grinding but can be done and apparently provides a bit more go due the enlarged throttle body diameter and the better flow characteristics of the rev+ inlet.