![](./images/smilies/spacer.gif)
Just purchased MartinF's link g3 with map sensor and 800 injectors.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
He's kindly supplied it with the loom from ecu right through to the engine so I could either swap them over or see where to modify my loom to fit the link.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
What i'd like to do is have a Harness adaptor to plug from my std loom into the link without any cutting of my loom but I don't think link sell them anymore as the g3 is old to them.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
So, can I buy the connectors anywhere to make one? Anyone done this?
![](./images/smilies/spacer.gif)
Any suggestions welcomed.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Bri