Hi, recently removed my exhaust manifold on my Rev 1 tubby. Unsurprisingly its warped put a straight edge across each of the two halves, and its fine, but across the whole manifold its about 2mm out.
Is it possible / sensible to have it machined flat? anyone have anywhere that can be trusted to do it if so in the Midlands or Sheffield area?
Cheers
Ant
[Mk2] [Turbo] Warped Exh Manifold
Moderators: IMOC Moderators, IMOC Committee Members
Re: [Mk2] [Turbo] Warped Exh Manifold
I don't know anywhere you could get it machined but I've got one you can buy for £40 if you're happy to pick up. I can look at postage if required it's quite heavy though.
At a guess i'd say the cost of machining would be more than buying a second hand one.
At a guess i'd say the cost of machining would be more than buying a second hand one.
Re: [Mk2] [Turbo] Warped Exh Manifold
Thanks Draven, i'll keep that in mind. I'll look into postage. I assume yours is straight.
Oddly enough I relocated from your area to Shropshire just under a year ago !!
Cheers
Oddly enough I relocated from your area to Shropshire just under a year ago !!
Cheers
Re: [Mk2] [Turbo] Warped Exh Manifold
Haha.
Yes i'm pretty sure it is straight. I'm doing some work in my garage at the weekend so i'll hold a straight edge up to it and let you know.
Yes i'm pretty sure it is straight. I'm doing some work in my garage at the weekend so i'll hold a straight edge up to it and let you know.
-
- Posts: 1844
- Joined: Sun Jan 30, 2005 1:22 pm
Re: [Mk2] [Turbo] Warped Exh Manifold
It should be fairly easy to get that manifold face decked flat - I would suggest, if you are stuck, contacting Peter Gidden at sbits as he has access to a number of machine shops or as it might be closer to you try Nathan at Century Motorsport - again he has access to machine shops. Hope this helps a bit.
Re: [Mk2] [Turbo] Warped Exh Manifold
Cool, thanks chaps
Re: [Mk2] [Turbo] Warped Exh Manifold
No worries.
Re: [Mk2] [Turbo] Warped Exh Manifold
Judderman wrote:Hi, recently removed my exhaust manifold on my Rev 1 tubby. Unsurprisingly its warped put a straight edge across each of the two halves, and its fine, but across the whole manifold its about 2mm out.
Is it possible / sensible to have it machined flat? anyone have anywhere that can be trusted to do it if so in the Midlands or Sheffield area?
Cheers
Ant
If you can send it down me me I can mill it flat for you.
Designer for turbo set ups on F1 cars, and Nitrous Oxide Systems of the USA in the 80s
Re: [Mk2] [Turbo] Warped Exh Manifold
Thanks Bob, i'll PM you re costs.
Ant
Ant