![](./images/smilies/spacer.gif)
Ive placed a rev3 turbo engine into a rev3 NA body and have the ABS warning light on the dash and the ABS is definitely not working.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
For the engine swap, I used the engine wiring loom and the body loom
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I thought that maybe the abs ecu was knackered, but when I went to replace it with the turbo one I kept, the connections were different so I couldnt plug it in.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Ive checked all sensors for continuity and they look good, however there is no continuity from the sensor wires to the car, so Im guessing there is a problem caused from matching the two looms together.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Any help would be very much appreciated.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Thank in advance.
![](./images/smilies/spacer.gif)