![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Front: 16x7JJ offset 34
Rear: 16x8JJ offset 38
![](./images/smilies/spacer.gif)
Multi-fit hole pattern claiming to be 4x114
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Centre bore: 55mm?
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I'm thinking they will as Nissan GTST
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Thanks.
![](./images/smilies/spacer.gif)
Moderators: IMOC Moderators, IMOC Committee Members
Nic wrote:I'm assuming the 55mm is the center hole in the wheels and not the actual recess for the spigot? The MR2 spigot is 60.1mm which is why I ask, the R32 is 66.1mm so if they are off an R32 the diameter must be bigger than 55mm.
oVerboost wrote:If the centre bore is 55mm then they wont fit, you may need some hub adapters as the mr2 is 60.1mm centre bore.
You can go larger and use spiggot rings to make them snug, but not the other way around without the use of an adapter/spacer that converts the centre bore down to 55mm.
If they are 60.1 then you'll be fine as others have already said.![]()
![]()