This will no doubt say its my first post, but my old account

(its been a while) wont work!

Previously had a Rev1 turbo, but was racing it, andf it became very scary!

Anyway, now have a Mk1 which I love

(also have a MK2 for sandracing, but that's a different story), but the headlights were too high.

Simples I think- remove the 4 screws around the lights

(while they are up), adjust the rod thing on the side

(by removing it and shortening it

), and job done.

.

.

.

So now my lights wont pop up!

They will retract Ok afterwards, and have checked the two fuses in the frunk

(a 30 and 7.5) and the 60amp screwed in one in the back- all seem fine.

In fact all was fine til I bu88ered about!

Can you overshorten those rod things to lower light height?

Any suggestions?

All else in the car is good.

If I can get this sorted can finish the MK2 sand car!

Appreciated

Grant