Hi peeps,
![](./images/smilies/spacer.gif)
Have a strange problem.
![](./images/smilies/spacer.gif)
Had some work done and car was driving fine.
![](./images/smilies/spacer.gif)
Then alternator died and just before it went kaput the car was bogging down and struggling to get me to the closest service station but I made it in the end.
![](./images/smilies/spacer.gif)
Figured it was just struggling to power the fuel pump, injectors properly
![](./images/smilies/spacer.gif)
(battery light was on by that point and when I stopped alternator was smoking).
![](./images/smilies/spacer.gif)
Anyway it's been sitting on the drive for a while and we've changed the alternator and now it starts and idles fine, no warning lights but if you open the throttle quickly it splutters and then goes to about 2000rpm and just sits there spluttering.
![](./images/smilies/spacer.gif)
However if you open the throttle slowly it goes up the rev range ok and the throttle response to WOT when it's in the higher rpms is normal.
![](./images/smilies/spacer.gif)
When the engine is under load like when trying to drive the car, especially on an incline it hits the limit and splutters and stalls.
![](./images/smilies/spacer.gif)
Any idea what's causing this?
![](./images/smilies/spacer.gif)
I have a rev1 turbo with mines ecu
![](./images/smilies/spacer.gif)
Thanks