[Mk2] [Turbo] High clutch bite (new clutch)

[toecutter]

Have fitted an Exedy paddle clutch, bite point is too high, have adjusted and bled, made no difference.

When refitting the clutch slave cylinder, I had to push the cylinder into the bore to get it in place, does this mean the push rod is too long?

[Peter Gidden]

You should be able to adjust bite point by adjusting the push rod attached to the pedal.

[toecutter]

I adjusted that to get the amount of freeplay in the BGB spec, can I adjust it to get the correct bite even if it puts it out of spec?

[Peter Gidden]

I adjusted that to get the amount of freeplay in the BGB spec, can I adjust it to get the correct bite even if it puts it out of spec?

Yep.

[toecutter]

Good stuff cheers

[Driftlimits Performance]

er not quite you absolutely must have free play. Change the length to aquire the biting point, and the stops to allow freeplay.

complete clutch kit? Was it new?

[toecutter]

So after I set the bite where I want it, I adjust the stops to suit?
Yeah was a new complete kit from cam skill.