I've just replaced the clutch master cylinder and after many hours of trying, can't get a full pedal.
![](./images/smilies/spacer.gif)
I pulled fluid through to the slave by vacuum and then bled the normal way
![](./images/smilies/spacer.gif)
(and a few variations) but it always comes to the same point with only the bottom 25% of the pedal doing anything and this isn't enough to release the clutch.
![](./images/smilies/spacer.gif)
On the last try I bled through a full litre of fluid and it came out without any air bubbles in
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.but still the majority of pedal travel does nothing.
![](./images/smilies/spacer.gif)
This is the 3rd MR2 clutch master cylinder that I've changed and I know they are a pain to bleed out but this one is something else.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
;((((
Any ideas will be very well received.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)