As title, have taken out the rubber tipped bolt and the retaining clip, according to engine removal guides I read it should then slide out of carrier no bother.
I had to unbolt the support from the block to pull shaft from gearbox.
Bearing has a fair bit of play in it so I want to change it - am I missing a trick here or are they usually jammed in?
[Mk2] [Turbo] Driveshaft support bearing stuck in carrier
Moderators: IMOC Moderators, IMOC Committee Members
Re: [Mk2] [Turbo] Driveshaft support bearing stuck in carrier
toecutter wrote:As title, have taken out the rubber tipped bolt and the retaining clip, according to engine removal guides I read it should then slide out of carrier no bother.
I had to unbolt the support from the block to pull shaft from gearbox.
Bearing has a fair bit of play in it so I want to change it - am I missing a trick here or are they usually jammed in?
You will need to press it off
Designer for turbo set ups on F1 cars, and Nitrous Oxide Systems of the USA in the 80s
Re: [Mk2] [Turbo] Driveshaft support bearing stuck in carrier
Thanks the press did it.