new projet 2 tone

Discussion and technical advice for 84-89 AW10 & AW11 MR2. 3A-LU, 4A-GE, 4A-GZE.

Moderators: IMOC Moderators, IMOC Committee Members

mk1 dal
Posts: 227
Joined: Mon Jul 14, 2008 12:46 am
Location: buxton

new projet 2 tone

Post by mk1 dal »

hi , i sold my white over gray car and took this car in as a trade in for something to do over the winter months . its not to bad at all only needing the rear arch doing rust wise .

pics off car after a bloody good mopping

Image

Image

wanting to keep the cost down on this project i used an old front wing for a replacement for the rear arch , the profile is spot on but is only good for about 40 mm of lip edge anymore and you will need the replacement arch of ebay or the n12 cherry arch what Paul woods discovered fits years ago .

arch cut out

Image

tacked in then fully welded .

Image

Image

the rear arch return fabricated and welded in and blended with the arch

Image

Image

lining out for the 2 tone , 6mm and 3 mm lining tape used for the arch profiles , the original paint was flatted first and then bar coated then 2 packed primed ready for the base coat .

Image

in base coat

Image

Image

then clear coat put on and unwrapping the result and loving it , the blue is super editions blue and its a fabulous colour .

hope you like it , i do

Image

Image

Image

Image

click on pic to see vid

Image

Image

Image

Image

gary

:thumleft:
wilki
Posts: 320
Joined: Tue Feb 01, 2011 8:52 pm
Location: Barnoldswick

Re: new projet 2 tone

Post by wilki »

The two tone has come off fantastically, you must be chuffed with it :thumleft:

Very nice mk1, intrested to see what else you do to her
8)
Image
mk1 dal
Posts: 227
Joined: Mon Jul 14, 2008 12:46 am
Location: buxton

Re: new projet 2 tone

Post by mk1 dal »

hi thanks mate , i not sure what to do about the wheels . i could polish the tear drops or go for some deep dish wheels . the pin strips are going to be gold to match the original blue colour . the engine bay needs cleaning up and i have started already with pics to follow soon .

gary
wilki
Posts: 320
Joined: Tue Feb 01, 2011 8:52 pm
Location: Barnoldswick

Re: new projet 2 tone

Post by wilki »

Deep dish alloys, do it!!! :lol:

yea the gold should go well :thumleft:
Image
wilkie senior
IMOC Moderator
Posts: 2061
Joined: Tue Feb 01, 2011 8:53 pm
Location: Barnoldswick

Re: new projet 2 tone

Post by wilkie senior »

DEEP DISH!!!!!!!!!!!!!!!!! lol
Image
That's a negative, Jim. I do not have the measles.
Hail Cosmos Eagle Rev 5, 1998 -
RIP White Eagle Rev 1, 1991 - 2016
PW@Woodsport
Posts: 7642
Joined: Tue Dec 14, 2004 6:40 pm
Location: durham
Contact:

Re: new projet 2 tone

Post by PW@Woodsport »

Nice job on the arch repair, but it looks like you painted straight over the sideskirts and seals in situ? Is it still white under there?

Naughty naughty [-X

Looks nice though. :thumleft:
Image
Tiger Tim
Posts: 220
Joined: Tue May 22, 2007 11:18 am
Location: Ireland

Re: new projet 2 tone

Post by Tiger Tim »

Great job. Looks fantastic .Just wondering is there a ridge between Blue & White & how do you blend it in?.

T.
mk1 dal
Posts: 227
Joined: Mon Jul 14, 2008 12:46 am
Location: buxton

Re: new projet 2 tone

Post by mk1 dal »

PW@Woodsport wrote:Nice job on the arch repair, but it looks like you painted straight over the sideskirts and seals in situ? Is it still white under there?

Naughty naughty [-X

Looks nice though. :thumleft:


hi paul , not been naughty mate :lol: . i painted the bottom first, removed all the kit and front splitters as the drivers side was damaged and replaced with a new one . i then refitted the lot with a few fixings so i could paint it easier and get a even spray on the kit to match the main body .

gary :thumleft:
mk1 dal
Posts: 227
Joined: Mon Jul 14, 2008 12:46 am
Location: buxton

Re: new projet 2 tone

Post by mk1 dal »

Tiger Tim wrote:Great job. Looks fantastic .Just wondering is there a ridge between Blue & White & how do you blend it in?.

T.


hi tim , there is a ridge between the blue and white but its very slight , the only way to blend it in is to lacquer the sides of the car , this will then seal over the ridge , but i would have the do the whole car so it matched up . this will be done over x mas when i change the white to 040 white in stead of 043 white .
PW@Woodsport
Posts: 7642
Joined: Tue Dec 14, 2004 6:40 pm
Location: durham
Contact:

Re: new projet 2 tone

Post by PW@Woodsport »

mk1 dal wrote:
PW@Woodsport wrote:Nice job on the arch repair, but it looks like you painted straight over the sideskirts and seals in situ? Is it still white under there?

Naughty naughty [-X

Looks nice though. :thumleft:


hi paul , not been naughty mate :lol: . i painted the bottom first, removed all the kit and front splitters as the drivers side was damaged and replaced with a new one . i then refitted the lot with a few fixings so i could paint it easier and get a even spray on the kit to match the main body .

gary :thumleft:



Good man Gary, being a painter myself it's a personal hate of mine when people just paint over things like that , top job :thumleft:
Image
pk_090
Posts: 1968
Joined: Fri Jun 03, 2011 9:39 pm
Location: Stoke on trent, staffordshire

Re: new projet 2 tone

Post by pk_090 »

OH MY GOD!
That looks awesome Gary!
platmatt8 wrote:Lauren has got bigger balls than most men on this site

charged wrote:Mine's probably screaming 'stop raping me' :D
mk1 dal
Posts: 227
Joined: Mon Jul 14, 2008 12:46 am
Location: buxton

Re: new projet 2 tone

Post by mk1 dal »

hi thanks for comments guys :thumleft: . now the holidays are here and 2 weeks off and plenty of time on my hands i can get more done on the car , suspension and brakes . the engine bay is now coming along and cleaned up nice .

Image

Image

Image
still lots to do but its getting there .

gary :thumleft:
Finn
Posts: 208
Joined: Fri Mar 02, 2012 2:06 pm
Location: Finland
Contact:

Re: new projet 2 tone

Post by Finn »

Me likey. :salut:
muckyman
Posts: 473
Joined: Tue Sep 20, 2005 5:03 pm

Re: new projet 2 tone

Post by muckyman »

Finn wrote:Me likey. :salut:


Me too. A lot.
muckyman
Posts: 473
Joined: Tue Sep 20, 2005 5:03 pm

Re: new projet 2 tone

Post by muckyman »

is it just me, or does the drivers side headlight need realigned a little to close up the gap between the lid and the bumper?
(still loving the paint scheme)
0233winch
Posts: 32
Joined: Thu Jan 12, 2012 11:27 am

Re: new projet 2 tone

Post by 0233winch »

Love what you've done! the arches didn't look to bad your lucky mine are awful.
mk1 dal
Posts: 227
Joined: Mon Jul 14, 2008 12:46 am
Location: buxton

Re: new projet 2 tone

Post by mk1 dal »

muckyman wrote:is it just me, or does the drivers side headlight need realigned a little to close up the gap between the lid and the bumper?
(still loving the paint scheme)


well spotted mate ,its the cover on the p1$$ and it needs resetting .

got some new pics i took today .

Image

Image

Image


and my new car im doing up for tatton show .

Image

Image

Image
jumpman33
Posts: 38
Joined: Fri Aug 17, 2012 10:55 pm
Location: United Kingdom

Re: new projet 2 tone

Post by jumpman33 »

Love the colour of your new one, definately my favourite!
Swap mine for that one when you've done with it after tatton :)
User avatar
Lauren
IMOC Committee
Posts: 38632
Joined: Mon Dec 13, 2004 5:37 pm
Location: Greater Manchester
Contact:

Re: new projet 2 tone

Post by Lauren »

It looks good enough from a distance, the pics are very low res.

What's it like?
2020 GR Yaris - Circuit Pack :lover:
mk1 dal
Posts: 227
Joined: Mon Jul 14, 2008 12:46 am
Location: buxton

Re: new projet 2 tone

Post by mk1 dal »

Lauren wrote:It looks good enough from a distance, the pics are very low res.

What's it like?


its very good body wise with very very little corrosion and runs a treat but the paint looks tried with slight peel on the bonnet . it did machine polish up but it still needs a fresh paint job to be right .
Post Reply

Return to “MR2 MK1 1984-1989 NA & SC”