there is a link to how to fit them into a mk1 from basshunter at top of this thread
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
it is very similar to that
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
seat belt went straight in no need to change
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
ignore the measurements that they give for cutting down the runners
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
i just measured origional and cut them to that
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
only thing i cant get exactly right is the bearings on the runners
![](./images/smilies/spacer.gif)
.there is one at each end and when u cut runner down one will fall out
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
no problem putting back but they jammed when adjusting seat
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
there are 3 sets of small raised nipples
![](./images/smilies/spacer.gif)
(cant think wot to call them but u will understand when looking
![](./images/smilies/spacer.gif)
) i filed the middle set down and seat will adjust but not very smooth
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
this was on passenger side and i have set right back and dont see any need to adjust
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
on the drivers side i left the bearing out and seat can be adjusted but not sat in it
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
again only i intend on driving car so once set doesnt need moving
![](./images/smilies/spacer.gif)
.sorry no pics
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
you will need a good drill and a few
![](./images/smilies/spacer.gif)
6mm and 1x 8mm drill bit
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)