![](./images/smilies/spacer.gif)
Just a quickie, fitting a boost controller to a rev 2 turbo with a ct20b turbo from a rev 3.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I have searched but can't find any specifically with this set up i.e rev 2 engine with ct20b turbo
![Smile :-)](./images/smilies/icon_smile.gif)
![](./images/smilies/spacer.gif)
Cheers in advance!!!
![](./images/smilies/spacer.gif)
Aaron
Moderators: IMOC Moderators, IMOC Committee Members
dantheman wrote:Depends if you have changed the head gasket from cork to metal.if you havent i think no more than 14 psi.
if you have, my understanding is that because the CT20b is more efficient than the CT26 above 14psi you can go up to about 16 psi, as you will actually be getting more usable pressure not just hotter air.
Anything above 16 psi and the injectors which are already maxed out simply cant maintain a safe A/F ratio.
nikaiyo wrote:dantheman wrote:Depends if you have changed the head gasket from cork to metal.if you havent i think no more than 14 psi.
if you have, my understanding is that because the CT20b is more efficient than the CT26 above 14psi you can go up to about 16 psi, as you will actually be getting more usable pressure not just hotter air.
Anything above 16 psi and the injectors which are already maxed out simply cant maintain a safe A/F ratio.
Rev 3's have stainless HG as standard
nikaiyo wrote:Rev 3's have stainless HG as standard
swaggansway wrote:I am getting 300bhp with CT20b but I have many other mods