Ok - I know the stud pattern is different, what needs to be done?
Will I need any gasketts, if so do I buy rev1/2 or rev3 gasketts?
Is it worth me getting an uprated actuator for it?
Should I get my Dastek re-mapped too?
Any one in Essex or may be London wanna take on the job for me?
Need Some Advice - Fitting A CT20b To Rev2
Moderators: IMOC Moderators, IMOC Committee Members
Need Some Advice - Fitting A CT20b To Rev2
Last edited by matt_mr2t on Wed Jul 20, 2005 11:15 am, edited 1 time in total.
Re: Need Some Advice - Fitting A CT20b To Rev2
And another thing - will the hose from the indcution kit still fit the housing?
Re: Need Some Advice - Fitting A CT20b To Rev2
Oil feed pipe is different from what I can remember (mayby JJ or Dino can clarify), but gaskets and everything else are the same - apart from the extra stud that needs removing.
HTH.
EarL.
HTH.
EarL.
Sable Grey 2004 MkIII Roadster
Once an MR2 owner, ALWAYS an MR2 owner!
Once an MR2 owner, ALWAYS an MR2 owner!
Re: Need Some Advice - Fitting A CT20b To Rev2
Is it much work to mod the oil feed to fit?