the engine has a rattle once reved ive been told its possable the small end baring
how hard is it to change and will it have caused damage to the rest of the engine?
[Mk2] [NA] small end bearing change?
Moderators: IMOC Moderators, IMOC Committee Members
-
- Posts: 362
- Joined: Sun Jun 15, 2008 12:54 am
- Location: Gravesend Kent
[Mk2] [NA] small end bearing change?
Not So Fast But Just As Furious =]
-
- Posts: 229
- Joined: Wed Apr 26, 2006 4:54 pm
- Location: South Wiltshire
- Contact:
Re: [Mk2] [NA] small end bearing change?
little end bearing is found within the connecting rod...
http://www.toyodiy.com/parts/p_E_1990_T ... ?hl=13201A
indeed they do wear and are often overlooked as part of a (forged) engine rebuild when re-using stock rods, but i would be very surprised if this was at fault in your case.
http://www.toyodiy.com/parts/p_E_1990_T ... ?hl=13201A
indeed they do wear and are often overlooked as part of a (forged) engine rebuild when re-using stock rods, but i would be very surprised if this was at fault in your case.
-
- Posts: 362
- Joined: Sun Jun 15, 2008 12:54 am
- Location: Gravesend Kent
Re: [Mk2] [NA] small end bearing change?
if it wouls stop raining id get a vid but damn weather if i knew what was up with it id have a go at fixing it but im not 100% on the problem
Not So Fast But Just As Furious =]
Re: [Mk2] [NA] small end bearing change?
Its likely the butterfly mechanism in the inlet manifold, that operates the T-VIS.
Take the top section of the inlet manifold off its only four bolts I think and you`ll see what I mean.
Take the top section of the inlet manifold off its only four bolts I think and you`ll see what I mean.
-
- Posts: 362
- Joined: Sun Jun 15, 2008 12:54 am
- Location: Gravesend Kent
Re: [Mk2] [NA] small end bearing change?
would that make a loud tapping noise once reved?
Not So Fast But Just As Furious =]