rogue fan kit thread bore information?

Discussion and technical advice the SW20 MR2. 3S-GTE, 3S-GE, 3S-FE etc
Anything and everything to do with maintenance, modifications and electrical is in here for the Mk2.

Moderators: IMOC Moderators, IMOC Committee Members

Post Reply
demonslayer
Posts: 4
Joined: Fri Aug 06, 2021 9:18 pm
Location: germany

rogue fan kit thread bore information?

Post by demonslayer »

Hi Everyone,

I am trying to find out the threads on the mid-section of the good old rogue fan shroud.
Somehow it must be something m5 -ish. The others surrounding sure are m6.
I am not able to mount my temp sensor at the moment/After reinstalling this kit again.
I know I had the temp sensor mounted once, i see the marks, but I have no clue which bolts I used.
Maybe one of You can check this for me on his/her lid/shroud.

thank you,
Dan


[/img]
demonslayer
Posts: 4
Joined: Fri Aug 06, 2021 9:18 pm
Location: germany

Re: rogue fan kit thread bore information?

Post by demonslayer »

Hello, can someone help please?
User avatar
wilkie senior
IMOC Moderator
Posts: 2057
Joined: Tue Feb 01, 2011 8:53 pm
Location: Barnoldswick

Re: rogue fan kit thread bore information?

Post by wilkie senior »

I dont think that are that many Rogue shrouds around to try but surely they would be using the same as the std bolts to fasten the sensor on?

I would suggest you would have more luck contacting Rougue directly?

regards Brian
Last edited by wilkie senior on Wed Aug 11, 2021 1:02 pm, edited 1 time in total.
Image
That's a negative, Jim. I do not have the measles.
Hail Cosmos Eagle Rev 5, 1998 -
RIP White Eagle Rev 1, 1991 - 2016
User avatar
wilkie senior
IMOC Moderator
Posts: 2057
Joined: Tue Feb 01, 2011 8:53 pm
Location: Barnoldswick

Re: rogue fan kit thread bore information?

Post by wilkie senior »

std bolts would be as i recall m6x1.0 metric bolts

I will have a check round for you
Image
That's a negative, Jim. I do not have the measles.
Hail Cosmos Eagle Rev 5, 1998 -
RIP White Eagle Rev 1, 1991 - 2016
demonslayer
Posts: 4
Joined: Fri Aug 06, 2021 9:18 pm
Location: germany

Re: rogue fan kit thread bore information?

Post by demonslayer »

Thank you,
I contacted Rogue, and they tried to help me. In any case they dont have such shrouds to check for me, but are certain they used metric tapings.
So I removed the shroud and checked its rear side/ the threads, and realized that powder coat drained into the last section of the threads.

So its M5x0.8 metric for these 2 holes on the sensor.

All other main bolts are M6x1 metric .

mystery solved :)

Now I have to think about how and where to connect the dual Spals that the temp sensor controls them. As they drain quiet some amps they should go to a Batterie + somewhere.
Post Reply

Return to “MR2 MK2 1990 - 1999 NA & Turbo”