www.imoc.co.uk

Do same springs fit all variants? Turbo, NA, Bilstein, rebuildables, 1 spring fits all?

What condition are the rears in?
Thanks

Where abouts are you? I'll probably take the springs!
Thanks
Dan

Nice clean MR2. Love the LS's aswell, I miss my LS400 badly!

Thanks all, can't see anything listed on Owen developments or h tune sites though. Heard good things about vibrant around the internet. Of the UK ones I've found this site looks good if you can believe the advert. Male female flange, sleeves over the pipe etc. http://rndmotorsport.co.uk/epages/95000...

I'm after a 3" v band joint to finish my new exhaust.

There are plenty of them on eBay but I don't want to buy crap that doesnt fit together properly, seal properly, warp or corrode.

Anybody have a recommendation for a good source of quality v band flanges and clamps in the UK?

Thanks
Dan

Can you send me some photos of the side skirts? Photos in post not working
Cheers
Dan

Bump, top quality, good condition!

I'll be there,

Unfortunately the date I was most looking forward to at Blyton clashes with my holiday!

But will be there for the 2nd one!

Price Drop to £800

New photo's above

Intercooler fan connector
AC Compressor connectors
Lambda Sensor connector

Are usually around that area

MR2 Eddy high quality A pillar single gauge pod for MK2 MR2 Replaces the whole OEM A pillar trim so the gauge pod is fully integrated For Non T-Bar cars. These are rare, high quality parts with excellent fit and finish. http://i292.photobucket.com/albums/mm18/Danbob101/IMG_20161231_181939_zpsgjuctnm...

Which tracks has it made friends with?

Interested

Good news!

Still waiting for pics of the dump valve if you have them
Cheers
Dan

BSP is available in both tapered and parallel
BSPT
BSPP

BSP tapered is more common than BSP parallel in my experience

Yes that is what they mean

The bottom of the downpipe isn't two feet from the turbo, hence the question.

Cheers, exactly what I was hoping to hear!

Yeah LC2 instructions say 24" but I'll give it a go in the lower downpipe position

Cheers
Dan

Hello all, My aftermarket downpipe has a lambda boss towards the bottom of the pipe, as I believe most do. I was intending to use it for my wideband However, Innovate wideband instructions state that the sensor should be mounted 2 foot downstream of the turbo to prevent overheating/damage to the sen...

Mine came with an engine I bought and had to strip down for parts as the block was no good. Ok, if they were only adjusted a couple degrees on the cam gears and idled fine it's possible that what Milo is saying is still my problem and the hks cam card specs are too far out for it to idle properly. T...