www.imoc.co.uk

Right'o ive been searcing for an hour now, and cant find a simple diagram of where the cold start injector is, anyone help me on this?

From what i've read i can just remove it? Then plum my temp sensor into there to get inlet temp readings?

Robbed from Cvega666 in other read, simliar to these on the revII inlent mani

Thanks for that jim, as i've never stripped an entire mr2 engine down i really don't know where you mean. On the intake manifold there are two holes already on the back, 1 runs to the A/C idle up valve and 1 is fully blocked, these were the holes i was on about plumbing into it. I'll search where yo...

Not 100% sure really, lots of places sell them.

I generally just whack what i want into google search and look around various sites for cheaper deals.

Take a look at the likes of the affiliates on IMOC and also do some google / ebay searching thats what i do anyway!

Camskill is worth a look also

Thanks for that, think im going to be installing it into the rubber sock before the throttle body, and silicone seal it in.

ARB's and bushes after what 4ndee said, that's what im getting next.

I was thinking of doing this once i had some more cashflow, can't see why there would be a problem using spal fans.

Nice car/progress fella, and nice job with the ash tray temp reading. Looks well done. What's the refresh rate on the temp display? Hi, thanks for comment :) I didn't manage to fully install it at the weekend, as I've been having issues with sensor location, currently doing a bodge installation in ...

Oki slight problem! im trying to install my temp sesnor to monitor intake temps and i cant figure out how to install it, seems best location is to put it into the AC idle up location? I dont have aircon as its all been removed and the end pipe is blocked off after the sensor unit. So can i just get ...

Oki thought you meant those will check on mine tomorrow!

hmm, maybe a silly question... do you have to drill those open?

Machined up my ashtray today at work, to house the LCD screen looks pretty good to me, what you guys think? http://i898.photobucket.com/albums/ac184/Dayloz/ashtraymod003.jpg And a question! Where is the best place to tap into for inlet temperatures, bearing in mind i have a ST205 CC, so its a rubber...

Machined the ashtray today at work, think it looks pretty good :) Going to try install it all tomorrow, just not sure where im going to fit the thermocouple to measure the inlet temps. Pics! http://i898.photobucket.com/albums/ac184/Dayloz/ashtraymod001.jpg http://i898.photobucket.com/albums/ac184/Da...

Looks amazing, good work

timlowthian wrote:Id definatly be interested in an engine bay one! Refuse to replace the stay clip for the 3rd time

What he said! cost me like £10 for the last one.

I'm in

Just found this guide maybe this help you?

http://www.sure-electronics.net/downloa ... 1.0_EN.pdf

Edit: rofl, great minds think alike

Edit 2: Seems have to adjust the little minature sliders on the inside

Should be good fun anyway!

ahh, thanks for the heads up i'll take it into work 2moro and get the sparky engineer on the case

A few small bits i ordered to finish off my CC setup, swirl pot from GT4 CC which i received today from gazrev1tubby and new LCD temp monitor, with thermocouple sensor. Plan is to machine out the ashtray tomorrow at work and fit the LCD screen so only the red screen shows instead of the grey surroun...

Sensor came today, pretty good delivery time from hong kong.

Going to try to try rig this up at the weekend

Had mine done recently, cam belt and pulley kit, water pump, flush off coolant and new coolant cost me £261

So yours sounds like a bargain