www.imoc.co.uk

Do you happen to know the hose diameters of the cb20 turbo inlet and outlet. I'm changing over from the st205 cooler to the bigger one like androo7 had on his. It has 89mm air in ond out. I'm going to run it on the standard cb20 turbo till, i can afforded a gtx3071. would be nice to know that i can ...

Thanks

I wasn't sure if you could bend these to any angle you wanted.

https://www.skyinsurance.co.uk/blog/wp- ... 00x225.jpg like the one in this pic

I'm trying to get some of this black silicone hose, that i keep seeing on cars. It has a bit of a ribbed look to it. I think craig had it on his anyone know what i mean.

When you said Berk i was thinking down pipes.

What a motor, I hope it has good traction control

Is that a new mr2 body kit, nice. Only joking, very nice car. Is it the same as mr Gidons. what sort of power dose it have.

That will make no difference what so ever It doesn't actually crack on the bolt hole Am I right to think that a small percentage of forged engines crack between cylinders 2 and 3, possibly to do with to high a compression piston, knock and a thin cylinder wall. And are there a small percentage that...

Someone explain it

Apparently, when you put your ARP head studs into the block and hand tight down, the one in the corner by the water pump should be tightened down till it bottoms out then backed off about 1mm and held in place with some lock tight. This is supposed to stop the block cracking over the water pump prob...

Turns out the answer is no.

Can you still get rebuild kits for a TRD lsd. and if so where from. thanks.

Scholar Engines, there not that far away and know their stuff. http://www.scholarengines.co.uk/

You don't know do you.

How much are they from Toyota.

PM'd

This guy has them. https://www.gt4-play.co.uk/shop/

Are you going to use oil squirters on the 5s block, and what head gasket are you using

pm'd