He said that he also checked the coolant and found it to be a little yucky but counld not detect any fuel or oil in it. you need a sniffer test mate, find out if there's exhaust gas in the coolant, and also a leak test please clarify the above wazza2. was the following exhaust gas / hydrocarbon tes...
if you skim the head and deck the block, then it will be OK fit a TRD/TTE multilayer steel head gasket. £70- £80 delivered direct from toyota-f1 in Germany ;) same product as Fensport, but without the Fensport tax! http://www.imoc.co.uk/forums/viewtopic.php?t=86253&highlight= a metal headgasket ...
i use the (TTE) Toyota Team Europe grpA multilayer steel gasket , available in 1.2mm or 1.4mm. Application: SW20 rev1&2, ST165, ST185 3sgte. http://i32.photobucket.com/albums/d38/skintbinlid/head%20gasket/TTEhgeoe1.jpg ordered it direct from TTE / Toyota-F1 in Germany (no import taxes or extra V...
i'm no expert on MR2 (wrong forum for me :oops: ) but from what i've read :confused: the SW21 9807-0003. My Toyota EPC does not have this listing... Is that a USDM vehicle and uses the normally aspirated 2.2l 5S-FE engine? > > was there ever a 3sgte built July 1998 > March 2000 on a SW2# chassis?
Stock Toyota rev3 /ST205 = AISIN brand clutch. It is good for 300+ ft lb if you don't try and dump the xxxx out of it >> drag style. Any clutch will wear quick if you subject it to abuse ;) As a daily drive the stock unit is hard to beat. 300 /320 torque won't cause the clutch to slip on the move un...
Found this on another forum: http://www.gt4dc.co.uk/forum/viewtopic.php?t=2109&highlight= looks promising 8) New rev3 custom IM_opened_development is done! Yeehaaaaaaaaaaaa! http://i215.photobucket.com/albums/cc237/Prochorus_familiaris/IMready.jpg http://i215.photobucket.com/albums/cc237/Prochor...
Ah hello there Gary! What sort of power is the md228 capable of? md228 power? :dunno: i've yet to try it on max hairdryer setting v.high. i would expect around the same 400 ish after many mapping and datalogging sessions. You seen Tony@Cambridge's spec on his on the GT4OC? He is running a md117 wit...
Hi Mike 4.1, Been using a Turbo Dynamics MD228 (57mm trim TO4E wheel ) for the last 2-3 years / 8000 miles on stock ST185 ECU. Has held steady boost a 1.0- 1.1 bar when mated to a 3" aussie downpipe, ST185 cylinder head and stock 2" ST165 exhaust. Pushes alot more air than the CT26 ever di...
i used "Jizer" engine degreaser, lots of soaking and srubbed using a plastic type brillo / dish pad followed by more soaking etc... and a dollop of elbow grease
Funny you should say about side mount throttle body Ryan, looking on the us mr2 site ,one of the old threads went into this,and it seems the earlier celica engines inlet manifold does basically line up,albeit a little bit of modding would be neccassary(throttle cable relocation etc). I understand a...