www.imoc.co.uk

http://www.mrtwo.net/mr2modproject/service/hfh/hfh.htm

ink here how to do it

Could it be timing related or perhaps clogged fuel filter?

Dude, this is not cool.

/Thread

If the intake scoop was sealed airtight into your air box I could see it helping. If not, then no.

Front drivers 60.5cm. Front passenger 62cm. Rear drivers 64 rear pass 61.

So they are a bit crazy. Floor not 100% flat or level but still.

i have stock wheels and tyres from a Rev3! Bump steer yar!! i did just buy a used set of 'billies' and springs from the bay of E but they are getting shipped back due to being not 3 years old as described. so i am after a new non bank busting solution. So i read on another build thread the rears can...

Strange. i mean i am fully polybushed from steering rack to ARB to all arms and gear linkages. I wonder if its just the rear springs sagging under the extra weight and the front end is too light combined with harsher springs and struts makes it skip over bumps when the front hits them rather than ri...

Not sure if i have bad springs or what but they look OE to me on my Rev 3 and its a hella crashy ride.

Its like have my springs been cut? i cant believe any standard springs are this redicolous on a normal car and if it was lowered any more id be:/

Hit small bump = brace youself!

Refurb caliper time:/

Coolant..maybe t stat. Check turbo elbow from the intake (prone to cracking). Calipers..!!

Hi guys, can anyone who has an MR2 turbo do me a favour? Next time you have your car running pull the PCV from the cam cover on the right hand side, at idle how much gas should be flowing if any?

thanks to anyone who takes the time.

2.4bar?! SWEET

i like how the advert says HKS a lot.

The internal dia is about 75/76 mm

Forgot to check last night, the part was about £25 quid as i remmeber, but the elbow is made up of 2 parts from toyota. you only need one of them as i remember

i'd like a kit that sprays a bit of water onto the outside of the Intercooler and evaps off? is that possible.

mine was cracked and splitting at the same place luckily my garage spotted it before it got heinous.

i bought a new part from toyota and fitted it as a straight replacement. When i get home from work i will measure the broken one as i still have it lying around the outhouse if you'd like?

Fronts are bilstein rear have hexagonal nut...ffff

i they look like this. Unfortunately I've left them at my parents so don't have them to hand

Hi, so I bought a set of used billies from ebay, however, upon checking the rear struts, I cant make out a bilstein sticker and it has TOYOTA embossed into the strut casing, is this still a bilstein? Also did a quick bounce test out the back and turned the fronts upside down and pushed down on them,...

Yea I;'ve just whipped the rain tray off, hardest bit was unscrewing the temp sensor and doing it single handed so it required me to prop the lid up with my shoulder and attack the rain tray screw at an arkward angle. all done now anyway, will test later.