www.imoc.co.uk

just wondering has anyone tried , or is it possible to fit some sport seats from a celica vvti

turbo arrived my mistake its a ct20 lol

wots the top two studs for ,, i can see where the oil feed pipes go but the ones above it what are those for






wots the difference between a ct20 and ct20b ,,,,, plus is a ct20 a straight swap froma ct26

wicked cheers guys

does the oil feed pipe need bending at all or does it fit alright ,, just there pretty weak have snapped one before

after 3 weeks in the garage i phoned again and appearently they cant get the right seals and toyota dont have them anymore :thumleft: but thanks to the lad on here i phoned up with the parts numbers and low and behold there coming in moday for me so aint going back to that garage again ](*,) how eas...

oh do i have to take of the oil filter and cooler to get to the down pipe bolts...

Cheers guys big help ,, that oil return pipe is a pain in the ar$e I replaced mine a few months back and cracked it trying to fit it off to Toyota again lol
cheers tho big help

just a cheecky is there a step by step guide to remove the the ct26 and replace with ct20b

right pulling my hairout here with my local garage had my car 3 weeks changing the drive shaft seal on ds they keep saying they got the wrong seal ,,, i have a k reg 1993 rev 2 turbo import what seal do i need andwot part number is it ? they told me there looking into it as there 3 different ttypes ...

cool cheers recently replaced those on the banjo so save a few bob now cheers mate

just wondering what gaskets i would need as im swapping turbos soon ,, are these the right ones i need Exhaust manifold gasket - 17173-88382 (Rev1) Water by pass gasket -16347-88380 (Rev1) Gasket turbine outlet elbow - 17279-88480 (Rev3+) GASKET, TURBO OIL INLET (Oil Pipe to Turbo) - 15471-88380 (Re...

just fitted mine today and had the same problem the pipe work just doesnt bend enough to line up with the throttle body and now i have a boost leak lol

Say again gumbo...so I don't have to disconnect the water feed pipes to get the extension bar to the banjo....brilliant :thumleft: no mate remove the heat sheild then there a big clamp that fits the turbo to the manidfold ,, 2 bolts undo them , give it a little tap with a hammer should come off,,, ...

i did this a few times now lol ,, can be a sod ,, getting the banjo lined up and gasket in place is a pain in the ar$e ,, just be carefullwith the banjo bolt makesure it goes in striaght ,,,, i removed the metal clamp thats hold the turbo in place ,, then fed a long exntension pole through the there...

i fitted a blueprint caliper about 1yr ago no porobs yet

cheers mate downloaded it , but thats only for the 2 rear cables i need to the centre one that connects to the handbrake its self

typical just about to go in for my mot and snap bang the handbrake cable went ,, its not the 2 rear one its the centre cable how do u replace it ,, i cant use the how to thread in knowledge base i dont have power point ](*,) i take it this is the part i need http://www.camskill.co.uk/products.php?pl...

replaced mine with new ones from toyota dont recall seeing dents like that in them

my kids call mine the beast so its kinda stuck with that

Peter Gidden - SBITS wrote:Give us a clue... model? revision? import?

soz rev2 gts import